BACK
Products
LIST

SY Series Pneumatic Y Type Trap

Characteristic:

The valve body is forged Y type, with small flow resistance and large Cv value.

There is a throttle plate on the valve core, which effectively protects the sealing surface and prolongs the service life of the valve.

The valve core and seat are surfacing welded with hard alloy, which is anti-cavitation and erosion-resistant through special technology and processing.

There are two guide rings on the valve core, the valve stem is balanced in force, and the action is flexible, and it is not easy to jam.

The stem packing is all imported from the United States Garlock, which has good chemical properties and flexibility, low friction, zero leakage, and long service life (average can be used for 4-5 years).

The switching speed is fast, generally 3~5 seconds, which effectively protects the safety of the system and greatly reduces the time that the sealing surface is washed by the medium.

There is a heat sink on the valve cover to fully dissipate heat to ensure that accessories such as pneumatic actuators and solenoid valves will not fail due to high temperature impact (the heat sink design is designed in cooperation with Shanghai East China University of Science and Technology).

The middle cavity gasket is a high-mesh flexible graphite gasket with a wire, which has better sealing characteristics and reliability than general flexible graphite gaskets.


Application range:

It is widely used in thermal power plants and other industries, installed on the steam pipes of thermal power units, and can be divided into:

Main steam pipe trap;

Reheat pipe trap;

Cold and reheat pipe traps;

One, two, three, four, five, six extraction pipe traps and others.


Design Standards:

Design and manufacture: ASME B16.34 JB/T3595

Inspection and test: JB/T3595 MSS SP-61

Connection end:

       Socket welding: ASME B16.11

       Butt welding: ASME B16.25

       Flange connection: ASME B16.5

Technical Parameters:  

Nominal diameter: 3/4″~ 6″

Nominal pressure rating: ANSI 150lb ~ 4500lb

Medium temperature: ≤ 610℃

Actuator: Pneumatic actuator

Air source pressure (MPa) 0.2 ~ 0.3

Spring range (KPa) 20-100; 80-200;

Leakage: zero leakage

Performance Parameters:

Body type: Y type 45° angle

Body material: A105, F22, F91, F92, F316L, F316H, F304

Bonnet: basic type, heat dissipation type

Trim: Integral surfacing valve seat

Packing: flexible graphite with stainless steel wire

Flow characteristics: quick opening

Two types of actuators are available for Selection:

       1. Pneumatic diaphragm actuator

       2. Piston type actuator

           Top-mounted and side-mounted handwheels are available for selection.